112 Troubleshooting Your SystemTroubleshooting the Video Subsystem1 Check the system and power connections to the monitor.2 Check the video interface cabling from the system to the monitor.3 Run the appropriate online diagnostic test. See "Using Online Diagnostics"on page 127.If the tests run successfully, the problem is not related to video hardware.If the tests fail, see "Getting Help" on page 135.Troubleshooting a USB DeviceUse the following steps to troubleshoot a USB keyboard/mouse. For otherUSB devices, go to step 4.1 Disconnect the keyboard and mouse cables from the system briefly andreconnect them.2 Connect the keyboard/mouse to the USB port(s) on the opposite side ofthe system.3 If the problem is resolved, restart the system, enter the System Setupprogram, and check if the nonfunctioning USB ports are enabled.4 Replace the keyboard/mouse with another working keyboard/mouse.5 If the problem is resolved, replace the faulty keyboard/mouse.6 If the problem is not resolved, proceed to the next step to begintroubleshooting the other USB devices attached to the system.7 Power down all attached USB devices and disconnect them from thesystem.8 Restart the system and, if your keyboard is functioning, enter the systemsetup program. Verify that all USB ports are enabled. See "IntegratedDevices Screen" on page 41.If your keyboard is not functioning, you can also use remote access. If thesystem is not accessible, see "Disabling a Forgotten Password" on page 134for instructions on setting the NVRAM_CLR jumper inside your systemand restoring the BIOS to the default settings.9 Reconnect and power on each USB device one at a time.
