Installing The Server Module PartitionsCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. If installed, remove the front bezel.2. Turn off the server modules using the operating system commands or the CMC.3. Turn off the enclosure, including any attached peripherals, and disconnect the enclosure from the electrical outletand peripherals.4. Remove the server modules or server module blanks.5. To install the server module partition between Slots 1 and 3:a) Angle the partition and slide it into the chassis.b) Align the tabs on the partition with the slots on the outer chassis wall and insert the tabs into the slots.c) Rotate the partition downward in the clockwise direction until the tabs on the other side of the partition engagewith the slots on the metal partition.d) Slide the partition toward the back of the system until the release tab on the partition engages with the slot onthe chassis wall.Figure 41. Installing the Server Module Partition Between Slots 1 and 31. outer chassis wall 2. tabs on server module partition3. slots on the outer chassis wall 4. slots on the metal partition5. tabs on the server module partition 6. metal partition62
