Dell PowerVault 130T DLT Service Manual

Also see for POWER VAULT 130T LIBRARY 130T: Installation guide Installation guide User guide Safety booklet

Contents

Dell PowerVault 130T DLT Service Manual Manual pdf 57 page image

PowerVault 130T Service Manual Electronics Module4473D 3–21Figure 3–7. Electronics Module (and CYC card) showing Cable Locations10. Reaching into the access door, disconnect J17, J25, J31, J37 and J39 cables from theirconnectors on the CYC card. (The CYC card is the large controller card mounted to theelectronics module.) Use a flashlight to see, if necessary.NOTE: The connectors are different and are therefore removed differently. For example,connector J37 requires that you loosen its thumbscrews before you can remove it. Someconnectors require you to pinchtabs together or push tabs apart.11. Disconnect the tape drive power cables from the electronics module power receptacles.CAUTION: Failure to disconnect all the cables described above will cause cabledamage and possibly card connector damage when you slide out the electronicsmodule. When the cables are disconnected, take care not to snag them on theelectronics module when you slide it out.12. Slide the electronics module out of the library, verifying that all cables are disconnected.13. Place the damaged electronics module on a flat, stable surface.WARNING: Do not apply power to the electronics module assembly when it is notinstalled in the PowerVault 130T. (Refer to S04 in the Safety Booklet.)