Dell PowerVault DL2100 Hardware Owner's Manual

Also see for PowerVault DL2100: Installation instructions Installation instructions Update Getting started Configuration

Contents

Dell PowerVault DL2100 Hardware Owner's Manual Manual pdf 117 page image

Installing System Components 1172 Open the system. See Opening the System.3 Disconnect all cables connected to the expansion card.4 Remove all expansion cards from the expansion-card riser. See Removingan Expansion Card.5 Press the tab at the bottom of the riser to release the board from the cardslot and lift expansion-card riser 1 off of the mounting pins and out of thesystem. See Figure 3-23.Replacing Expansion-Card Riser 1NOTE: The system will not start with a riser board removed.1 Aligning the pin collar over the mounting pin on the system board, lowerexpansion-card riser 1 until the board connector is firmly seated into thesystem board socket. See Figure 3-23.2 Reinstall any expansion cards. See "Installing an Expansion Card."3 Reconnect all expansion-card cables.4 Close the system. See "Closing the System."5 Reconnect your system and peripherals to their electrical outlets, and turnon the system.