Dell PowerVault MD3200 Getting Started

Also see for PowerVault MD3200 Series: Manual Update Rack Installation Instructions Owner's manual Support Matrix

Contents

Dell PowerVault MD3200 Getting Started Manual pdf 14 page image

12 Getting Started With Your SystemTechnical SpecificationsDrivesPowerVault MD3200 Up to twelve 3.5-inch SAS hot-swappablehard drives (3.0 Gbps and 6.0 Gbps)PowerVault MD3220 Up to twenty four 2.5-inch SAS hot-swappablehard drives (3.0 Gbps and 6.0 Gbps)RAID Controller ModulesRAID controller modules • One or two hot-swappable modules withtemperature sensors• 2 GB of cache per controllerBack-Panel Connectors (Per RAID Controller Module)SAS connectors • Four SAS IN ports to connect hosts• One SAS OUT port for expansion to an additionalPowerVault MD1200 series enclosureNOTE: SAS connectors are SFF-8088 compliant.Serial connector One 6-pin mini-DIN connectorNOTE: For technical support use only.Management EthernetconnectorOne 100/1000 Base-T port Ethernet for out-of-bandmanagement of the enclosureNOTE: The default management port IP addresses forthe primary and secondary RAID controller modulesare 192.168.128.101 and 192.168.128.102, respectively.By default, the management ports are set to DynamicHost Configuration Protocol (DHCP). If the controlleris unable to get an IP address configuration froma DHCP server within a specified time out period(approximately 3 minutes), it defaults back tostatic IP addressing. For more information,see the Deployment Guide.