Installing System Components 133When the memory module is properly seated in the socket, the ejectors onthe memory module socket align with the ejectors on the other socketsthat have memory modules installed.8 Repeat step 5 through step 7 of this procedure to install the remainingmemory modules. See Table 3-2 or Table 3-3.9 Replace the cooling shroud. See "Installing the Cooling Shroud."10 Close the system. See "Closing the System."11 Reconnect your system and peripherals to their electrical outlets, and turnon the system.12 Press to enter the System Setup program, and check the SystemMemory setting on the main System Setup screen.The system should have already changed the value to reflect the newlyinstalled memory.13 If the value is incorrect, one or more of the memory modules may not beinstalled properly. Repeat step 2 through step 12 of this procedure,checking to ensure that the memory modules are firmly seated in theirsockets.14 Run the system memory test in the system diagnostics. See "Running theEmbedded System Diagnostics."Removing Memory ModulesWARNING: Only trained service technicians are authorized to remove the systemcover and access any of the components inside the system. Before you begin thisprocedure, review the safety instructions that came with the system.WARNING: The memory modules are hot to the touch for some time after thesystem has been powered down. Allow time for the memory modules to coolbefore handling them. Handle the memory modules by the card edges and avoidtouching the components on the memory module.1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet.2 Open the system. See "Opening the System."3 Remove the cooling shroud. See "Removing the Cooling Shroud."4 Locate the memory module sockets. See Figure 6-2.
