Installing System Components 89Removing the Internal SD ModuleWARNING: Only trained service technicians are authorized to remove the systemcover and access any of the components inside the system. Before you begin thisprocedure, review the safety instructions that came with the system.1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet.2 Open the system. See "Opening the System."3 Disconnect the cable from the internal SD module and from the controlpanel board. See Figure 3-8.4 Lift upwards on the latch securing the internal SD module to the chassis,then lift the tray out of the chassis. See Figure 3-8.5 Close the system. See "Closing the System."6 Reconnect the system and peripherals to their power sources, and turnthem on.Internal SD Flash CardInstalling the Internal SD Flash CardWARNING: Only trained service technicians are authorized to remove the systemcover and access any of the components inside the system. Before you begin thisprocedure, review the safety instructions that came with the system.NOTE: To use an SD card with your system, ensure that the internal SD card port isenabled in the System Setup program. See "Using the System Setup Program andUEFI Boot Manager."1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet.2 Open the system. See "Opening the System."3 Locate the SD card connector on the internal SD module and, with thelabel side facing up, insert the contact-pin end of the card into the slot.See Figure 3-8.NOTE: The slot is keyed to ensure correct insertion of the card.4 Press the card into the card slot to lock it into place.5 Close the system. See "Closing the System."
