Dell Precision M2400 Service Manual

Also see for Latitude E6400 ATG: Manual How-to guide How-to guide System Board Replacement How-to guide

Contents

Dell Precision M2400 Service Manual Manual pdf 52 page image

Replacing the Hard Drive1. Hold the hard drive with the label facing down.2. Place the pin on one end of the bezel into the hole on the hard drive.3. On the other end of the bezel, replace the M3 x 3-mm screw that secures the hard drive bezel to the hard drive.4. Slide the hard drive into the hard drive bay.5. Replace the two M3 x 3-mm screws that secure the hard drive to the base assembly.6. Follow the procedures in After Working on Your Computer.7. Install the operating system, drivers, and utilities for your computer, as needed. For more information, see the Setup and Quick Reference Guide thatshipped with your computer or at support.dell.com.Removing the 1.8" Hard Drive (E6400 ATG)1. Follow the procedures in Working on Your Computer.2. Close the display and turn the computer upside down.3. Remove the two M3 x 3-mm screws.4. Slide the hard drive out of the base assembly.1 hard drive bezel 2 pin on bezel bracket3 hard drive 4 M3 x 3-mm screwCAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.NOTICE: Hard drives are extremely fragile. Exercise care when handling the hard drive.NOTICE: Use firm and even pressure to slide the hard drive into place. Excessive force may result in damage to the connector.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.CAUTION: Do not touch the metal housing of the hard drive if you remove the hard drive from the computer while the drive is hot.NOTICE: To prevent data loss, turn off your computer before removing the hard drive. Do not remove the hard drive while the computer is on orin Sleep state.NOTICE: Hard drives are extremely fragile. Exercise care when handling the hard drive.