Dell Precision Workstation 450 Service Manual

Also see for Precision Workstation 450: System information guide System information guide Setup and quick reference guide Setup and quick reference guide Setup and quick reference guide

Dell Precision Workstation 450 Service Manual Manual pdf 19 page image

Installing a Hard Drive1. Unpack the replacement hard drive, and prepare it for installation.2. Check the documentation for the drive to verify that it is configured for your computer.3. If your replacement hard drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secureeach rail to the drive. Attach the bracket rails to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails andthen inserting and tightening all four screws (two screws on each rail).4. Gently slide the drive into place until the tabs securely click into position.1 tabs (2)2 hard drive1 drive2 bracket rails (2)3 screws (4)NOTE: If you are installing a hard drive in the lower bay, the drive should be placed in the bay so that the power connector is on the left- hand side(opposite of the top hard drive).