Dell Precision Workstation 450 User Manual

Also see for Precision Workstation 450: System information guide System information guide Setup and quick reference guide Setup and quick reference guide Setup and quick reference guide

Contents

Dell Precision Workstation 450 User Manual Manual pdf 120 page image

3. Align the notch on the bottom of the VRM with the ridges inside the connector.4. Press the VRM straight down into the connector until the securing clips snap into place at the ends of the module.5. Install the microprocessor airflow shroud (for the Dell Precision 650 computer, see "Microprocessor Airflow Shroud" or for the Dell Precision 450computer, see "Microprocessor Airflow Shroud").6. Close the computer cover.7. Connect your computer and devices to electrical outlets, and turn them on.Removing a VRM1. Remove the microprocessor airflow shroud (for the Dell Precision 650 computer, see "Microprocessor Airflow Shroud" or for the Dell Precision 450computer, see "Microprocessor Airflow Shroud").2. Press the securing clips at each end of the connector outward simultaneously until the VRM slightly pops out from the connector.3. Grasp the VRM by its top corners, and ease it out of the connector.4. If you are installing a new VRM, see "Installing a VRM."If you are not installing a new VRM, continue with step 5.5. Install the microprocessor airflow shroud (for the Dell Precision 650 computer, see "Microprocessor Airflow Shroud" or for the Dell Precision 450computer, see "Microprocessor Airflow Shroud").6. Close the computer cover.7. Connect your computer and devices to electrical outlets, and turn them on.Back to Contents Page3 connectorNOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.CAUTION: Before you perform this procedure, follow the safety instructions in the System Information Guide.NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.