|
Dell EMC recommended switch configuration8 Dell EMC Networking S4148-ON and S4128-ON Switch Configuration Guide for Dell EMC SC Series SANs | SCG37042.3 Switch profiles (only for S4148-ON and its variants)On the S4148-ON switch and its variants, switch port profiles determine the available front-panel Ethernetports and supported breakout interfaces on uplink ports. Refer to the switch user’s guide to determine whichswitch profile fits for your environment.Note: Changing switch profiles will delete all configuration information from the switch except for themanagement port configuration. Save and reload the switch for the new switch profile to take effect.OS10# configure terminalOS10(config)# switch-port-profile 1/1 profile-Warning: Switch port profile will be applied only after a save and reload. Allmanagement port configurations will be retained but all other configurationswill be wiped out after the reload.OS10(config)# exitOS10# copy running-configuration startup-configurationOS10# reloadProceed to reboot the system? [confirm yes/no]yes2.4 Configure unified ports on S4148U-ONNote: This section applies to the S4148U-ON switch only. Skip this section if using other switches.This section configures unified ports on S4148U-ON switches to Ethernet ports. Refer to the switch user’sguide for further details. Port-group 1/1/1-1/1/6 refers to the first 24 SFP+ ports on the switch. Use thefollowing commands to convert these ports to Ethernet ports.OS10# configure terminalOS10(config)# port-group 1/1/OS10(conf-pg-1/1/1)# mode Eth 10g-4xOS10(conf-pg-1/1/1)# exitOS10(config)#Repeat the prior steps for port-group 1/1/1 to 1/1/6.Note: QSFP+ and QSFP28 ports are by default in Ethernet mode. They can be configured by configuringport-group 1/1/7-1/1/10 using the prior commands. Refer to the S4148-ON switch user’s guide for moreinformation.2.5 Configure out of band (OOB) management portOS10(config)# interface mgmt 1/1/1OS10(conf-if-ma-1/1/1)# no ip address dhcpOS10(conf-if-ma-1/1/1)# ip address /OS10(conf-if-ma-1/1/1)# exitOS10(config)# PreviousNext |