Dell Studio 1435 Service Manual

Also see for Studio 1435: User guide Setup guide

Back to Contents PageMemoryDell Studio™ 1435 Service ManualRemoving the Memory Module(s)Replacing the Memory Module(s)You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup Guide for information on thememory supported by your computer. Install only memory modules that are intended for your computer.Your computer has two user-accessible SODIMM sockets that can be accessed from the bottom of the computer. The DIMM B memory module is located directlyabove the DIMM A memory module located on the bottom of the computer.Removing the Memory Module(s)1. Follow the procedures in Before You Begin.2. Turn the computer over and remove the base cover (see Removing the Base Cover).3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.4. Remove the memory module from the connector.Replacing the Memory Module(s)1. Align the notch in the module edge connector with the tab in the connector slot.2. Slide the module firmly into the slot at a 45-degree angle, and press the module down until it clicks into place. If you do not feel the click, remove themodule and reinstall it.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.NOTE: Memory modules purchased from Dell are covered under your computer warranty.NOTICE: If you need to install memory modules in both connectors, install a memory module in the lower connector before you install a module in theupper connector.NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (suchas a connector on the back of the computer).NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.1 memory module connector 2 securing clip (2)3 memory moduleNOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (suchas a connector on the back of the computer).NOTE: If the memory module is not installed properly, the computer may not boot.