Dell Studio 1450 Service Manual

Also see for Studio 1457: User guide Setup guide Service manual

Dell Studio 1450 Service Manual Manual pdf 31 page image

Back to Contents PageMemoryRemoving the Memory Module(s)Replacing the Memory Module(s)You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup Guide for information on thetype of memory supported by your computer. Install only memory modules that are compatible with your computer.Your computer has two user-accessible SODIMM sockets that can be accessed from the bottom of the computer.Removing the Memory Module(s)1. Follow the procedures in Before You Begin.2. Remove the battery (see Removing the Battery).3. Remove the base cover (see Removing the Base Cover).4. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the memory module pops up.5. Remove the memory module from the memory module connector.Replacing the Memory Module(s)1. Follow the procedures in Before You Begin.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside thecomputer.NOTE: Memory modules purchased from Dell are covered under your computer warranty.CAUTION: To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.1 memory module connector 2 memory module3 securing clips (2)