Dell Studio Desktop Service Manual

Also see for 540 - USB Photo Printer 540: User guide Owner's manual Setup guide Specification User guide

Contents

Back to Contents PageReplacing the Front I/O PanelDell Studio™ 540 Service Manual1. Follow the procedures in Before You Begin.2. Remove the computer cover (see Replacing the Computer Cover).3. Remove the front panel (see Replacing the Front Panel).4. Remove any expansion cards (see Replacing a PCI/PCI Express Card).5. Disconnect the cables connected to the I/O panel from the system board.6. Remove the screw that secures the I/O panel to the chassis.7. Carefully remove the existing I/O panel from the computer.8. To replace a new I/O panel, align and slide the I/O panel clamp into the I/O panel clamp slot.9. Replace the screw that secures the I/O panel to the chassis.10. Reconnect the cables to the system board.11. Replace any expansion cards (see Replacing a PCI/PCI Express Card).12. Replace the front panel (see Replacing the Front Panel).13. Replace the computer cover (see Replacing the Computer Cover).14. Connect your computer and devices to an electrical outlet, and turn them on.Back to Contents PageCAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.NOTICE: Carefully note the routing of each cable before you disconnect it, so that you are sure to re-route cables correctly. An incorrectly routed or adisconnected cable could lead to computer problems.1 I/O panel clamp slot 2 I/O panel clamp3 screw 4 I/O panel5 cables