114 Removing and Installing PartsNOTICE: To avoid damage to the memory module, press the module straight downinto the connector while you apply equal force to each end of the module.4 Insert the module into the connector until the module snaps into position.If you insert the module correctly, the securing clips snap into the cutoutsat each end of the module.5 Replace the PCI Express x16 card. See "Cards" on page 115.6 Replace the computer cover.NOTICE: To connect a network cable, first plug the cable into the network deviceand then plug it into the computer.7 Connect your computer and devices to electrical outlets, and turn them on.8 Right-click the My Computer icon and click Properties.9 Click the General tab.10 To verify that the memory is installed correctly, check the amount ofmemory (RAM) listed.Removing MemoryCAUTION: Before you begin any of the procedures in this section, follow thesafety instructions in the Product Information Guide.CAUTION: Before removing memory, you must remove the PCI Express x16 card.See "Cards" on page 115.
