Safety Instructions 1354 Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.5 Wait for approximately five seconds to clear the password.6 Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2and 3 to enable the password feature.7 Follow the procedure in "After Working on Your Computer" on page 45.Clearing CMOS SettingsCAUTION: Before working inside your computer, read the safety information thatshipped with your computer. For additional safety best practices information, seethe Regulatory Compliance Homepage at www.dell.com/regulatory_compliance1 Follow the procedures in "Before Working on Your Computer" on page 35.NOTE: The computer must be disconnected from the electrical outlet to clearthe CMOS setting.2 Remove the computer cover (see "Removing the Computer Cover" onpage 47).3 Reset the current CMOS settings:a Locate the 3-pin CMOS jumper (CLEAR CMOS) on the systemboard (see "System Board Components" on page 40).b Remove the jumper plug from the CMOS jumper (CLEAR CMOS)pins 2 and 3.c Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1and 2 and wait approximately five seconds.d Remove the jumper plug and replace it on the CMOS jumper(CLEAR CMOS) pins 2 and 3.4 Follow the procedure in "After Working on Your Computer" on page 45.5 Reboot your computer.Your computer will emit five beeps, and then issue a CMOS checksumerror.6 Press to continue.Downloaded from www.Manualslib.com manuals search engine
