![Dell Vostro 410 Service Manual Manual pdf 28 page image](https://manuals-archive2.s3.amazonaws.com/4999022/4cc9f0cfbe2ca4d5537e15ea5b890af828f.jpg)
Back to Contents PageI/O PanelDell™ Vostro™ 410 Service ManualRemoving the I/O PanelReplacing the I/O PanelRemoving the I/O Panel1. Follow the procedures in Before Working on Your Computer.2. Remove the computer cover (see Removing the Computer Cover).3. Remove the bezel (see Removing the Bezel).4. Disconnect the I/O panel cables from the system board.5. Remove the screw that secures the I/O panel.6. Slide the I/O panel down to release the I/O panel clamp from the I/O panel clamp slot.7. Carefully remove the I/O panel and cables from the chassis.Replacing the I/O Panel1. Route the I/O panel cables into the chassis through the I/O panel slot. Align and slide the I/O panel clamp up into the I/O panel clamp slot.2. Replace and tighten the screw that secures the I/O panel.CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage on www.dell.com at the following location:www.dell.com/regulatory_compliance.CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.NOTE: Note the routing of all cables as you remove them so that you can reroute them correctly when installing the new I/O panel.NOTICE: When sliding the I/O panel out of the computer, be extremely careful to prevent damage to the cable connectors and the cable routing clips.1 I/O panel screw hole 2 I/O panel3 screw (1)NOTICE: Take care not to damage the cable connectors and the cable routing clips when sliding the I/O panel into the computer.