Dell W-7030 Installation Manual

Contents

Dell W-7030 Installation Manual Manual pdf 19 page image

Dell Networking W-7030 Controller | Installation Guide Installation | 11Figure 4 Attaching the Wall Mount Brackets2. After choosing a mounting location, mark the locations on the wall for the mounting holes.3. Create the holes and insert wall anchors if the installation requires them.4. Align the mounting bracket holes with the holes created in the wall (see Figure 5).Figure 5 Wall Mounting5. Use appropriate screws to secure the W-7030 controller.Connecting and Disconnecting the AC Power CordOnce the controller is installed, it is ready to be powered on. The W-7030 controller is not equipped with an on/off switch. The device will power on when the AC power cord is connected to the AC inlet and an AC poweroutlet.Connecting the AC Power CordTo connect the AC power cord to the W-7030 controller:1. Lift the power cord retaining clip so that it is not blocking the AC power connector.2. Insert the coupler end of the AC power cord into the AC power connector on the AC inlet.3. Lower the power cord retaining clip over the AC power cord.The W-7030 controller should now be receiving power.Disconnecting the AC Power CordTo disconnect the AC power cord from the W-7030 controller:1. Lift the power cord retaining clip off the AC power cord.