Option DescriptionDefault setting: Not setSystem Password Allows you to set, change or delete the system password.NOTE: Successful password changes take effect immediately.Default setting: Not setStrong Password Allows you to enforce the option to always set strong passwords.Default Setting: Enable Strong Password is not selected.NOTE: If Strong Password is enabled, Admin and System passwords must contain at least oneuppercase character, one lowercase character and be at least 8 characters long.PasswordConfigurationAllows you to determine the minimum and maximum length of Administrator and System passwords.Password Bypass Allows you to enable or disable the permission to bypass the System and the Internal HDD password, when theyare set. The options are:• Disabled• Reboot bypassDefault setting: DisabledPassword Change Allows you to enable the disable permission to the System and Hard Drive passwords when the admin password isset.Default setting: Allow Non-Admin Password Changes is selected.UEFI CapsuleFirmware UpdatesThis option controls whether the system allows BIOS updates through UEFI capsule update packages.NOTE: Disabling this option will block the BIOS updates from services such as Microsoft WindowsUpdate and Linux Vendor Firmware Service (LVFS).This option is enabled by default.TPM 2.0 Security Allows you to enable the Trusted Platform Module (TPM) during POST. This option is enabled by default. Theoptions are:• TPM On• Clear• PPI Bypass for Enabled Commands• PPI Bypass for Disabled CommandsNOTE: Activation, deactivation, and clear options are not affected if you load the setup program'sdefault values. Changes to this option take effect immediately.Computrace Allows you to activate or disable the optional Computrace software The options are:• Deactivate• Disable• ActivateNOTE: The Activate and Disable options will permanently activate or disable the feature and no furtherchanges will be allowed50 System setup