Dell XPS 13 9300 Service Manual

Also see for XPS 13 9300: Setup and specifications

Contents

Dell XPS 13 9300 Service Manual Manual pdf 21 page image

Steps1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.2. Gently slide the solid-state drive into the solid-state drive slot.3. Align the solid-state drive shield with the alignment post, and align the screw hole on the solid-state drive shield with the screw hole onthe system board.NOTE: The size of the solid-state drive shield is specific to the size of the solid-state drive that is shipped with yourcomputer. The solid-state drive shield cannot be used for a different-sized solid-state drive.4. Replace the screw (M2x3) that secures the solid-state drive shield and the solid-state drive to the system board.5. Route the antenna cables through the routing guides on the system board toward the wireless card.6. Connect the antenna cables to the wireless card.7. Align the screw hole on the wireless-card bracket with the screw hole on the system board.NOTE: Ensure that tab on the wireless-card bracket is inserted into the slot in the system board.8. Tighten the captive screw that secures the wireless-card bracket to the system board.Next steps1. Install the base cover.2. Follow the procedure in After working inside your computer.Identifier GUID-E3C0201A-5B16-4C16-BB92-B961F39AE9F4Version 1Status ReleasedFansIdentifier GUID-DAF6C620-D491-4D47-BCB3-312D4F1E8AC5Version 1Status ReleasedRemoving the fansPrerequisites1. Follow the procedure in Before working inside your computer.2. Remove the base cover.About this taskThe following images indicate the location of the fans and provide a visual representation of the removal procedure.Removing and installing components 21