Identifier GUID-2DF70EB1-9D26-4051-8B7C-FB14A89925D8Status ReleasedReplacing the display assemblyWARNING: Before working inside your computer, read the safety information that shipped with your computer and follow thesteps in Before working inside your computer. After working inside your computer, follow the instructions in After working insideyour computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.Identifier GUID-9DE80CBE-AB75-4075-AFB5-F1C875EBD51EStatus ReleasedProcedure1 Place the palm-rest assembly at the edge of the table with the speakers facing away from the edge.2 Align the screw holes on the palm-rest assembly with the screw holes on the display hinges.3 Replace the six screws (M2.5x5) that secure the display assembly to the palm-rest assembly.4 Turn the computer over and open the display at an angle of 90 degrees.5 Adhere the tape that secures the touch-screen cable to the system board if applicable.6 Adhere the tape and connect the touch-screen cable to the system board if applicable.7 Adhere the tape that secures the display cable to the system board.8 Route the display cable through the routing guides on the left fan.NOTE: When routing the display cable, make sure that the cable is not routed over the screw hole on the left fan.9 Replace the screw (M2x2) that secures the display-cable bracket to the system board.Identifier GUID-96465A79-3284-4285-B73F-150E1B213336Status ReleasedPost-requisites1 Replace the wireless card.2 Replace the battery (half-length) or the battery (full-length).3 Replace the base cover.3874 Replacing the display assembly
