Table 9. System setup options—Connection menuConnectionWireless Device Enable Enable or disable internal WLAN/Bluetooth devices.By default, WLAN is selected.By default, Bluetooth is selected.Enable UEFI Network StackEnable UEFI Network Stack When enabled, UEFI networking protocols are installed and available, allowing pre-OSand early OS networking features to use any enabled NICs. This may be used withoutPXE turned on.Default: ONWireless Radio ControlControl WLAN radio Enables to sense the connection of the computer to a wired network andsubsequently disable the selected wireless radios (WLAN and/or WWAN). Upondisconnection from the wired network, the selected wireless radios are re-enabled.Default: OFFTable 10. System setup options—Power menuPowerBattery Configuration Enables the computer to run on battery during power usage hours. Use the belowoptions to prevent AC power usage between certain times of each day.By default Adaptive is selected.Advanced ConfigurationEnable Advanced Battery ChargeConfigurationEnables Advanced Battery Charge Configuration from the beginning of the day to aspecified work period. Advanced Battery Charged maximizes battery health while stillsupporting heavy use during the work day.Default: OFFPeak Shift Enables the computer to run on battery during peak power usage hours.Default: OFFThermal Management Sets cooling fan and processor heat management to adjust system performance,noise, and temperature.By default, Optimized is selected.USB Wake SupportWake on Dell USB-C Dock Enables connecting a Dell USB-C Dock to wake the computer from Standby.Default: ONBlock Sleep Blocks the computer from entering Sleep (S3) mode in the operating system.Default: OFFNOTE: If enabled, the computer will not go to sleep, Intel Rapid Start willbe disabled automatically, and the operating system power option will beblank if it was set to Sleep.Lid SwitchEnable Lid Switch Enables or disables the lid switch.Default: ONPower On Lid Open Enables the computer to power up from the off state whenever the lid is opened.Default: ON62 System setup