Dell XPS 410 Service Manual

Also see for XPS 410: Owner's manual Setup guide Service manual

Contents

10. Lift the fan release lever, then slide the fan toward the back of the computer to release the four fan tabs from the four slots in the bottom cover.11. Remove the fan from the computer.12. Disconnect the control-panel cable from the I/O panel connector by pulling with the cable loop.13. If present, disconnect the thermal sensor cable (twisted pair) from the I/O panel.14. Remove the drive panel (see Removing the Drive Panel).15. If an optional sound card is installed, disconnect the cable from the top edge of the I/O panel. Otherwise, a jumper block is installed.16. If an optional IEEE 1394 cable is installed in the front port, remove the cable from the front of the computer by following the instructions that came withthe connector.17. Remove the mounting screw from the front of the I/O panel.18. Remove the I/O panel from the computer.Installing the I/O Panel1 fan release lever 2 fan 3 drive panelNOTE: If the I/O panel has a jumper block installed and the replacement has no jumper block, then remove it from this I/O panel and install it in thereplacement I/O panel.1 mounting screw 2 I/O panel 3 control-panel cableCAUTION: When reinstalling the fan, ensure that you do not pinch the wires that run between the system board and the fan.