Dell XPS 430 Service Manual

Also see for XPS 430: User guide Quick reference guide Setting up Service manual

10. Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.11. Ensure that:l The tops of all cards and filler brackets are flush with the alignment bar.l The notch in the top of the card or filler bracket fits around the alignment guide.12. If you removed a card retention bracket, snap it into place, securing the PCI Express card.13. Replace the computer cover (see Replacing the Computer Cover).14. Connect the computer and devices to electrical outlets, and then turn them on.15. To complete the installation, see Configuring Your Computer After Removing or Installing PCI and PCI Express Cards.Configuring Your Computer After Removing or Installing PCI and PCI Express CardsNOTICE: Ensure that you release the securing tab to seat the card. If the card is not installed correctly, you may damage the system board.1 fully seated card 2 not fully seated card 3 bracket within slot4 bracket caught outside of slot 5 alignment bar 6 alignment guide1 release tab 2 card retention bracket 3 card retention doorNOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly orcause damage to the equipment.NOTICE: To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.NOTE: For information on location of connectors, see the Quick Reference Guide. For information on installing drivers and software for your card, see thedocumentation that shipped with the card.Installed RemovedSoundCard1. Enter system setup (seeSystem Setup).2. Go to Onboard Devicesand select Integrated1. Enter system setup (seeSystem Setup).2. Go to Onboard Devicesand select Integrated