Back to Contents PageReplacing Memory Module(s)Dell™ XPS™ 730/730X Service Manual1. Follow the procedures in Before You Begin.2. Remove the computer cover (see Replacing the Computer Cover).3. Locate the memory modules on the system board (see System Board Components).4. Press out the securing clip at each end of the memory module connector.5. Grasp the module and pull it upwards.If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.6. Ensure that you install a single memory module in DIMM connector 0, the connector closest to the processor, before you install modules in any otherconnector.Dell™ XPS™ 730:Dell XPS 730X:WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.1 securing clip 2 memory module connectorCAUTION: Do not install ECC memory modules.A matched pair of modules inDIMM connectors 0 and 1B matched pair of memory modules inDIMM connectors 2 and 3