Great user manuals database on UserManuals.info6. Wait for approximately five seconds to clear the password setting.7. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.8. Replace the system-board shield (see Replacing the System-Board Shield).9. Replace the back cover (see Replacing the Back Cover).10. Connect your computer and devices to electrical outlets, and turn them on.Clearing CMOS Passwords1. Follow the instructions in Before You Begin.2. Remove the back cover (see Removing the Back Cover).3. Remove the system-board shield (see Removing the System-Board Shield).4. Locate the 3-pin CMOS reset jumper (CLR_CMOS) on the system board. (see System Board Components).5. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.Inspiron One 2305CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so mayresult in damage to the computer.WARNING: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.WARNING: The computer must be disconnected from the electrical outlet to clear the CMOS setting.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).