Delta AH500 series Quick Start Manual

Also see for AH500 series: Hardware manual Programming manual Manual Operation manual Hardware operation manual

Delta AH500 series Quick Start Manual Manual pdf 14 page image

Ch ap te r 2 Prog ramming6. Analog input/output module (6 channels)AH06XA-5A x 1V 2V 1AIR1R0V 0V 1V 3V 3R3R2V 2V 0E RRO RRUN1 0V, 2 0m A1 0V,0 /4 ~ 20 m AFEUPV 0V 1I1ZPCO MAOI006XA2.1.2 SoftwareThe software needed in the example is as follows.z ISPSoft version 2.0 or abovez COMMGR version 1.0 or above2.1.3 Tools and MaterialsThe tools and the materials need in the example are as follows.z A personal computer in which the software mentioned above is installedz A 100~240 V AC and 50/60 Hz power supply socketz A 24 V DC power supplyz A cablez A screwdriverz An USB cable or a network cable (If users want to connect the Ethernet port or the COM port(RS-232/RS-485) on the CPU module to the computer, they can refer to section 2.3.2 inISPSoft User Manual for more information. If users want to know more about installing theUSB driver, they can refer to appendix A in AH500 Operation Manual.)z If necessary, users can prepare the accessories such as a switch and a bulb (to simulate theactivity of the external equipment).2.2 Installation2.2.1 Installing ModulesPlease install the modules on the main backplane, as illustrated below.Connect the module to the connector on the backplane, make sure that the module is installed onthe backplane properly, and tighen the the screw.2 - 3