Delta GT-9000 User Manual

Contents

Delta GT-9000 User Manual Manual pdf 7 page image

Helpline No. UK/Northern Ireland 0800 328 6020Rep. Ireland 00800 4467 5888E-mail Support info@dariolondon.comModel Number: GT-9000, GT-FSI-06-UKHelpline No. UK/Northern Ireland 0800 328 6020Rep. Ireland 00800 4467 5888E-mail Support info@dariolondon.comModel Number: GT-9000, GT-FSI-06-UK12 13Installation of the remote socketsPlug one of the remote sockets into the wall socket intended foruse, and then plug the desired electrical device (e.g. a lamp) intothe remote socket.Switch your electrical device on and then press the button onthe remote socket briefly.If you press the button briefly again, your electrical device willswitch off again.If the remote socket is already removed from the socket after avery short period of operation, the programming could be lost andmust be repeated. In normal operation, the programming can besaved for approx. 1 hour after being disconnected from the mains.In normal operation, the programming remains permanently whenseparated from the mains.Display on the remote socket• The control lamp illuminates when the remote socket is switched on.• The control lamp is off when the remote socket is switched on.Preparatory measuresThe remote control is equipped with four channels. You can allocatea dedicated channel to each remote socket, or you can use onechannel for several remote sockets, in order to switch them on/offat the same time.In order to allocate a channel to a remote socket, press thebutton on the respective remote socket and keep it pressed downfor approx. 2 seconds. Release the button and the LED display willflash for approx. 10 seconds. During this time, you can press thebutton on the remote control for the channel that you intend toallocate to this remote socket.As soon as the channel is allocated, the electrical device on therelevant remote socket will be switched on and the control lamp inthe remote socket will illuminate.In order to check whether the allocation works, press the relevantbutton and for the allocated channel.If the remote socket should not respond, repeat the allocationprocess.If the button does not work, the memory is full.Delete the existing code in the remote socket.Press the button for longer than 6 seconds, until the LEDdisplay starts to flash.All codes are now deleted.Allocation of the channels to theremote sockets