Denon AVR-1507 Operating Instructions Manual

Also see for AVR-1507: Brochure & specs Operating instructions Dimensions Service manual Service manual

Easy Setup Procedure Easy Setup Procedure11ENGLISHENGLISHr Starting Auto SetupPress FF to start the Auto Setup.• Start the measurements.Measurement of each channel is performed as follows:1Disconnect the setup mic to finish Auto Setup.3Cautions during measurements:• Loud test tones are output during the measurements. Be carefulfor example when small children are nearby.• Proper measurements may not be possible if there are obstaclesbetween the speaker and the setup microphone.• During the measurements, do not stand between or near thespeakers and setup microphone.• To avoid influencing the measurements, turn off the power of air-conditioners or any other equipment producing sound in theroom. Perform the measurements with the room as quiet aspossible.• Measurement is cancelled when VOLUME is operated while theAuto Setup is performed.FL FR C SW SL SR SBL SBR11: The subwoofer speaker is measured twice.After each channel is measured, “Calculating” appears.The display switches to the speaker check display automatically.M e a s u r e : F L < C c lC a l c u l a t i n gS p e a k e r : 3 / 4 / . 1¢ Check the results of the speaker detectionExample: 7.1-channel systemsS p e a k e r : 3 / 4 / . 1SubwooferSurround and Surround back speakerFront and Center speakerPress DD HH to select “Store”, then press FF.2Cancel:Cancel the checked measurement values.Store:Store the checked measurement values.All parameters are stored.Retry:Measure again.¢ About automatic retryTo confirm the results of the measurements, remeasurement isautomatically performed.Remeasurement is performed up to two times. During this time,“Retry1” or “Retry2” is displayed on the display.O v e r l o a d R e t r y 1• When measurements have been made using the measurementmicrophone, speakers with a built-in filter such as subwoofers mightbe set with a value that differs from the physical distance becauseof the internal electrical delay.NOTE:• Do not change the speaker connections or subwoofer volumeafter making the measurements.• Do not turn off the power while the data is being stored.S e t u p < S t o r e2S t o r i n g1 A u t o S e t < S t a r t