Denon AVR-1507 Operating Instructions Manual

Also see for AVR-1507: Brochure & specs Operating instructions Dimensions Service manual Service manual

Advanced Operation Advanced OperationENGLISHENGLISH35Viewing still pictures and videos(only for iPods equipped with the slideshow /video function)Press [MODE] for at least 2 seconds to switch from theBrowse mode to the Remote mode.• “Remote iPod” is displayed on the AVR-1507’s display.Watching the iPod’s screen, press [DD HH] to select“Photos” or “Video”, then press [ENTER] or [GG].• The iPod’s photo and video data are displayed on the monitor.Use this procedure to view photo and video data stored on the iPodon a monitor.12• To output photo or video data recorded on the iPod to the monitor,the iPod’s “TV Out” setting (under “Video Settings”) must be set to“ON”.For details, refer to the iPod’s operating instructions.Disconnecting the iPodPress or [OFF] and set the AVR-1507’spower to the standby mode.The iPod can be disconnected after switching to a function otherthan the one to which the iPod input is assigned.¢ Last function memoryThe various settings set when the AVR-1507’s power is switched tostandby are stored in the memory. When the power is turned back on,the settings made when the power was switched to standby arerecalled.About the memory functionsRecording the program source (recording thesource currently being monitored)¢ Backup memoryThe various settings are stored in the memory for about 1 week, evenwhen the power is turned off or the power cord is unplugged.Initialization of the microprocessorIf the indication on the display is not normal or if the operation of theunit is not correct, then the microprocessor should be reset by thefollowing procedure.Switch off the unit using .1Check that the entire display is flashing at 1-secondintervals and release the buttons.• The microprocessor will be initialized.3Keep both (A and B) depressed and turnon the unit by pressing .2• If step 3 does not work, start over from step 1.• If the microprocessor has been reset, all the button settings arereset to the default values (the values set upon shipment from thefactory).Select the input source to be played.1Start recording on the tape or video deck.For instructions, refer to the component’s operating instructions.3Select the input mode and play (surround) mode.2• The AUDIO IN’s signal selected with INPUT SELECTOR are output tothe CD-R/TAPE and VCR AUDIO OUT terminals.• Digital signals are not output to the audio output terminals.¢ Simultaneous recordingThe signals of the source selected with INPUT SELECTOR are outputsimultaneously to the CD-R/TAPE and VCR REC OUT terminals. If atotal of two tape and/or video decks are connected and set to therecording mode, the same source can be recorded simultaneously onevery decks.