Denon AVR-1508 Owner's Manual

Also see for AVR-1508: Comparison chart Code List Getting started guide Dimensions Manual Del Usuario

Denon AVR-1508 Owner's Manual Manual pdf 24 page image

Step 3 : CalculationWhen “Calculate” is selected at “Step 2”, the measurements taken are analyzed automaticallyto determine how the speaker system interacts with the room.“Calculate” is displayed when you have completed measurements in 6 positions. To completeStep 2 in 5 or less positions, press i to select “Calculate”.The time required for this analysis depends on the number of speakers connected. The higherthe number of speakers, the longer the time required for analysis.NOTEDo not change the speaker connections or subwoofer volume, or speaker locations after makingmeasurements. These types of changes will invalidate the EQ solution provided. If changesare necessary, make the changes and use the Audyssey MultEQ Auto Setup once again for anupdated EQ solution.Step 4 : CheckOnce the calculation is completed, a measuring result check (“Parameter Check”) is displayed.Press o to check the result.Press ui to select the item, then press o.Values that are different from the actual distance may be set for speakers with built-in fi lters(subwoofers, etc). This is because fi lters add electrical delay to the signal that should becompensated.NOTEDo not turn the power off while the settings are being stored.Step 5 : StoreThe auto setup measurement results are stored in the AVR-1508 or cancelled.After checking, press ENTER to select “Store”, then press ui to select “Store” or “Cancel”.Store : Press o to store this calibration permanently to memory.Cancel : Press o to cancel this calibration and clear all Auto Setup data measured.s Error MessagesIf the auto setup procedure could not be completed due to speaker installation, the measuring environment,etc. an error message is displayed. Check the relevant items and be sure to take the necessary measures. Afteraddressing any issues, perform the auto setup procedure over again.NOTE Be sure to turn the power off before checking speaker connections.Select “Retry” to make the measurements again.Error messages (examples) Cause MeasuresM i c o r S p : N O N E• The included setup microphone is notconnected.• Not all speakers could be detected.• Connect the included setupmicrophone to .• Check the speaker connections.A m b i e n t N o i s e• Too much noise in the room foraccurate measurements to be made.• Speaker or subwoofer sound is toolow for accurate measurements to bemade.• Either turn off any device generatingnoise or move it away.• Try again when the surroundings arequiter.• Check the speaker installation and thedirection in which the speakers arefacing.• Adjust the subwoofer’s volume.C a u t i o n : S p N o n eF R• Displayed speaker could not bedetected.· The front L and front R speakerswere not properly detected.· Only one channel of the surroundspeakers was detected.· Sound was output from the Rchannel when only one surroundback speaker was connected.· The surround back speaker wasdetected, but the surrounds werenot detected.• Check the connections of thedisplayed speaker.C a u t i o n : P h a s eS B L• Displayed speaker connected withthe polarities reversed.• Check the polarities of the displayedspeaker.• For some speakers, this errormessage may be displayed even ifthe speaker is properly connected. Ifyou are sure that the wiring is correct,select “Skip”.0Getting Started Connections Setup Playback Remote Control Multi-ZoneInformation TroubleshootingENGLISH