Denon AVR-1609 Owner's Manual

Also see for AVR-1609: Product Compatibility Chart Capabilites and Compatibilities Getting started Service manual Getting started

Denon AVR-1609 Owner's Manual Manual pdf 23 page image

0Getting Started Connections Playback Remote Control Multi-Zone Information TroubleshootingENGLISH SpecificationsStep 4 : Check• To proceed to “Step 5” without checking the analysis result, use u i to select “Store<”while “Parameter Check<” is displayed.• Values that are different from the actual distance may be set for speakers with built-in filters(subwoofers, etc). This is because filters add electrical delay to the signal that should becompensated.NOTEDo not turn the power off while the settings are being stored.Step 5 : StoreThe auto setup measurement results are stored in the AVR-1609.q Press o while “Store<” is displayed.• “Storing” blinks on the display panel while the results are being stored.• When storing is complete, “Completed” is displayed followed by “Disconnect Mic”.w Disconnect the setup microphone from the AVR-1609.s Error MessagesIf the auto setup procedure could not be completed due to speaker installation, the measuring environment,etc. an error message is displayed. Check the relevant items and be sure to take the necessary measures. Afteraddressing any issues, perform the auto setup procedure over again.NOTE Be sure to turn the power off before checking speaker connections.Select “Retry” to make the measurements again.Error messages (examples) Cause MeasuresM i c o r S p : N o n e• The included setup microphone is notconnected.• Not all speakers could be detected.• Connect the included setupmicrophone to .• Check the speaker connections.A m b i e n t N o i s e• Too much noise in the room foraccurate measurements to be made.• Speaker or subwoofer sound is toolow for accurate measurements to bemade.• Either turn off any device generatingnoise or move it away.• Try again when the surroundings arequieter.• Check the speaker installation and thedirection in which the speakers arefacing.• Adjust the subwoofer’s volume.C a u t i o n : S p N o n eThe messages alternateF R• Displayed speaker could not bedetected.· The front L and front R speakerswere not properly detected.· Only one channel of the surroundspeakers was detected.· Sound was output from the Rchannel when only one surroundback speaker was connected.· The surround back speaker wasdetected, but the surrounds werenot detected.• Check the connections of thedisplayed speaker.C a u t i o n : P h a s eThe messages alternateS B L• Displayed speaker connected withthe polarities reversed.• Check the polarities of the displayedspeaker.• For some speakers, this errormessage may be displayed even if thespeaker is properly connected. If theconnection is correct, use the u or ibuttons to display “Skip<” and thenpress o.n To switch to another analysis result itemPress ENTER.This returns you to analysis results items, so repeat operation q.n To proceed to “Step 5 : Store”During display of crossover frequency result or analysis results item, press ENTER.• “Store<” is displayed.n To cancel storingUse u or i to display “Cancel<” while “Store<” is displayed and press o.• All the measured auto setup data will be erased.When analysis is complete, “Parameter Check<” is displayed.Press o and check the analysis results for the following four items.q Make your selection using ui and press o.• Presence and size of speaker“SpConfig. Check<”• Distance of speaker from listening position“Distance Check<”• Speaker channel level“Ch Level Check<”• Crossover Frequency“Crossover Check<”w Use u or i to change which speaker is displayed.Setup