Denon AVR-1708 Owner's Manual

Also see for AVR-1708: Specifications Comparison chart Specifications Service manual Service manual

Denon AVR-1708 Owner's Manual Manual pdf 42 page image

Getting Started Connections Setup Playback Remote Control Multi-Zone Information TroubleshootingENGLISHGetting Started Connections Setup Playback Remote Control Multi-Zone Information TroubleshootingiPod® PlaybackThe music on an iPod can be played by using the Control Dock foriPod (ASD-1R, sold separately).The operation can also be performed using the buttons on theremote control unit.iPod is a trademark of Apple Inc., registered in the U.S.and other countries.b The iPod may only be used to copy or play contents that are notcopyrighted or contents for which copying or playback is legallypermitted for your private use as an individual. Be sure to complywith applicable copyright legislation.1 Make the necessary preparations.q Set the iPod in the DENON Control Dock for iPod.(vSee the Control Dock for iPod’s operating instructions.)w Assign the Control Dock for iPod’s input.“System Setup” –“Input Setup” – “iPod Assign” (vpage 26)2 Either turn or press [iPod] toselect the input source assigned in step 1-w above.R e m o t e i P o db If the displays above are not displayed, the iPod may not beproperly connected. Try connecting again.3 Set [MODE SELECTOR 1] to “AUDIO” and [MODESELECTOR 2] to “iPod/NETWORK”.(vpage 43 “Remote Control Unit Operations”)Basic Operation• With the default settings, the iPod can be used connected to the VCR(iPod) connector.• Use the RESTORER mode to expand the low and high frequencycomponents of compressed audio fi les and achieve a richer sound.The default setting is “Mode3” (vpage 33).• Press and set the AVR-1708’s power to the standbymode before disconnecting the iPod. Also switch the input source toone to which “iPod Assign” is not assigned before disconnecting theiPod. STATUSopuiAbout the button names in these explanations< > : Buttons on the main unit[ ] : Buttons on the remote control unitButton name only:Buttons on the main unit and remote control unituiop[1][6], [7][8], [9][2][ENTER][CHANNEL+/–]STATUS[MODESELECTOR 1] [MODESELECTOR 2]uiop [ENTER][iPod][MODE][Front][Rear]Searching Categories1 Press o p.C A T : R o c k2 Use o p to select the category, then use ui to selectthe desired station.Channel category• “LOADING” is displayed while stations or data are being received.• “UPDATING” is displayed while the encording code is beingupdated.• “XM – – –” is displayed if the selected channel cannot be used.NOTE• Depending on the type of iPod and the software version, somefunctions may not operate.• DENON will accept no responsibility whatsoever for any loss of iPoddata.