Denon AVR-1802/882 Operating Instructions Manual

Also see for AVR-1802: Brochure & specs Operating instructions Service manual Operating instructions Operating instructions

29ENGLISHSet the external input (EXT.IN) mode.Press the EXT. IN to switchthe external input.Once this is selected, the input signals connected to the FL(front left), FR (front right), C (center), SL (surround left), andSR (surround right) channels of the EXT. IN jacks are outputdirectly to the front (left and right), center, surround (left andright) speaker systems without passing through the surroundcircuitry.In addition, the signal input to the SW (subwoofer) jack isoutput to the PRE OUT SUBWOOFER jack.Playback using the external input (EXT. IN) jacks1 8(Main unit) (Remote control unit)2 Cancelling the external input modeTo cancel the external input (EXT. IN) setting, press the INPUTMODE (AUTO, PCM, DTS) or ANALOG button to switch tothe desired input mode. (See page 26.)8(Remote control unit)(Main unit)• When the input mode is set to the external input (EXT. IN), the playmode (STEREO, DOLBY/DTS SURROUND, 5CH STEREO or DSPSIMULATION) cannot be set.NOTES:• In play modes other than the external input mode, the signalsconnected to these jacks cannot be played. In addition, signalscannot be output from channels not connected to the inputjacks.• The external input mode can be set for any input source. Towatch video while listening to sound, select the input source towhich the video signal is connected, then set this mode.B2 1TV/DBSVCR-1 VCR-2SURROUNDMODETUNER SHIFTV. AUXINPUT MODE CDR / TAPECHANNELTAPE·VCR6 7849506 71, 2Recording the program source (recording the source currently being monitored)1 Follow step 1 to 3 under “Playing the input source” (page 26,27).The signals of the source selected with the function selector button are output simultaneously to the CDR/TAPE and VCR REC OUT jacks. Ifa total of two tape and/or video decks are connected and set to the recording mode, the same source can be recorded simultaneously onevery decks.NOTES:• The AUDIO IN’s signal selected with the function selector button are output to the CDR/TAPE and VCR AUDIO OUT jacks.• The DIGITAL IN’s signal selected with the function selector button are output to the DIGITAL OUT (OPTICAL) jack.2 Start recording on the tape or video deck.For instructions, refer to the component’s operatinginstructions.Simultaneous recording