Denon AVR-1908 Owner's Manual

Also see for AVR-1908: Specifications Comparison chart Specifications Owner's manual Service manual

Denon AVR-1908 Owner's Manual Manual pdf 13 page image

With HDMI connections, the video and audio signals can be transferred with a single cable.065)%.**/)%.*Compatibleaudio format Details Discs(examples)2-channel linearPCM2ch 32-192 kHz16/20/24 bitsCD, DVD-Video,DVD-AudioMulti-channellinear PCM8ch 32-192 kHz16/20/24 bits DVD-AudioDolby Digital, DTS Bitstream DVD-VideoMonitorDVD player b The AVR-1908 is equipped for HDMI version 1.3a. Thisversion is compatible with other versions, allowingconnection to all components equipped with an HDMIconnector.b The AVR-1908 is compatible with 30- and 36-bit DeepColor.Copyright protection system (HDCP)In order to play the digital video and audio signals of a DVD-Video or DVD-Audio disc using HDMI/DVI connections, boththe connected DVD player and monitor must be equippedfor a copyright protection system called “HDCP” (High-bandwidth Digital Content Protection).HDCP is a copy protection technology consisting of dataencoding and mutual identification of the devices.The AVR-1908 is HDCP-compatible. For details on theDVD player or monitor you are using, refer to its operatinginstructions.• When the AVR-1908 and DVD player are connected using an HDMI cable, also connect the AVR-1908 andmonitor using an HDMI cable.• If the connected monitor or DVD player only has a DVI-D connector, use an HDMI/DVI converter cable.When using a DVI cable, no audio signals are transmitted.• Use a Deep Color compatible cable for connection to Deep Color compatible devices.When connecting with an HDMI/DVI converter cable (adapter)• HDMI video signals are theoretically compatible with the DVI format.When connecting to a monitor, etc., equipped with a DVI-D connector, connection is possible using anHDMI/DVI converter cable, but depending on the combination of components in some cases the videosignals will not be output.• When connecting using an HDMI/DVI converter adapter, the video signals may not be output properlydue to poor connections with the connected cable, etc.• By default, the HDMI audio signals are output from the speakers connected to the AVR-1908.• To output the sound from the TV, make the settings at menu “Manual Setup” – “HDMI Setup” – “HDMIAudio Setup” – “TV” (vpage 25).NOTE• Use a CPPM-compatible DVD player to play DVD-Audio discs that are copyright-protected by CPPM.• The AVR-1908 cannot be controlled from another device via the HDMI cable.• The audio signals output from the HDMI connector (sampling frequency, bit rate, etc.) may be restrictedby the connected device.• Video signals are not output properly when using devices that are not HDCP-compatible.• Video signals are not output if the input video signals do not match the monitor’s resolution. In this case,switch the DVD player’s resolution to a resolution with which the monitor is compatible.• If the menu “Manual Setup” – “HDMI Setup” – “HDMI Audio Setup” setting (vpage 25) is set to“AMP”, the sound may be interrupted when the monitor’s power is turned off.• Use a cable on which the HDMI logo is indicated (a certified HDMI product) for connection to the HDMIconnector. Normal playback may not be possible when using a cable other than one on which the HDMIlogo is indicated (a non-HDMI-certified product).• If the monitor or DVD player does not support deep color, deep color signal transfer is not possible.• If the monitor or DVD player does not support xvYCC, xvYCC signal transfer is not possible.Connecting Equipment with HDMI connectorsGetting Started Connections Setup Playback Remote Control Amp Assign Information Troubleshooting