Denon AVR-1910 Owner's Manual

Also see for AVR1910 - Multi-Zone Home Theater Receiver: Specifications Specification Capabilites and Compatibilities Service manual Getting started

ENGLISHGetting Started Connections Playback Remote Control Information Troubleshooting SpecificationsMulti-ZoneSettingsNOTE• Insert the AC plugs securely. Incomplete connections could causenoise.• Only use the AC outlets to plug in audio equipment. Do not usethem as power supplies for hairdryers or anything other than audioequipment.Wait until all connections have been completed before connecting thepower cord.To householdpower outlet(AC 120 V, 60 Hz)Power cordConnection to the AC outlets• These outlets supply power to external au-dio equipment.• Audio equipment with a total power con-sumption of 120 W (1 A) can be connect-ed.• The power supply turns on and off togetherwith the on the main unit. When setto “ON”, power is supplied from the outlet.When set to “STANDBY”, no power is sup-plied.NOTEWhen “HDMI Control” (vpage 28) is setto “ON”, power is supplied constantly tothe AC outlet (UNSWITCHED).Once Connections areCompletedTurning the Power On1 Press .The power indicator lights red and thepower is set to the standby mode.2 Press .The power indicator flashes green and thepower turns on.b Also press when in standbymode, the power turns on.When has been pressed, the input source set with theis set. If a has been pressed, the input sourcestored in the memory for the quick select function is set (vpage50 “Saving frequently used settings (Quick Select Function)”).NOTE• Power continues to be supplied to some of the circuitry even whenthe power is in the standby mode. When leaving home for longperiods of time or when traveling, either press to turn off thepower, or unplug the power cord from the power outlet.• When the ZONE2 power is switched on, and you want to switch offthe MAIN ZONE power, press .Turning the Power Off1 Press .The power is set to the standby mode.2 Press .The power indicator turns off, and so doesthe power.This operation can also be performed by pressing a onthe main unit.FrontFrontConnecting the Power CordConnecting Devices not Equipped with HDMI terminalsDirection of broadcasting stationAM loopantenna(supplied)FM antenna75 Ω/ohmsCoaxial cableFM indoor antenna(supplied)GroundAM outdoor antennaNOTE• Do not connect two FM antennas simultaneously.• Even if an external AM antenna is used, do not disconnect the AMloop antenna.• Make sure the AM loop antenna lead terminals do not touch metalparts of the panel.Antenna terminalsn AM loop antenna assembly1 Remove the vinyl tie and take out theconnection line.2 Bend in the reverse direction.3 With the antenna on top of anystable surface.3 With the antenna attached to awall.-1-2MountInstallation hole Mount on wall, etc.1 Push the lever.2 Insert the conductor.n Connection of AM antennas3 Return the lever.Connections