Denon AVR-2309CI Owner's Manual

Also see for AVR-2309CI: Product Compatibility Chart Capabilites and Compatibilities Owner's manual Brochure & specs Getting started

Denon AVR-2309CI Owner's Manual Manual pdf 55 page image

Getting Started Connections Setup Remote Control Multi-zone Information TroubleshootingENGLISH SpecificationsSearching Categories1 Press [o p].SR001 Hits 1CAT : Pops2 Use [o p] to select the category, then use [ui] toselect the desired channel.Channel category• “UPDATING” is displayed while the encording code is beingupdated.• “SIRIUS UPDATING” is displayed when updating SIRIUS tunerfi rmware.• Refer to “Troubleshooting” – “SIRIUS Satellite Radio” regarding othermessages (vpage 75).Parental Lock1 Tune to the channel you want to lock.2 Press [ENTER] for at least 3 seconds.“Code: [ ]” is displayed.3 Enter the 4-digit lock code using uio p.When you enter the correct code, the corresponding channel islocked.4 Press [ENTER].• Channels under Parental Lock cannot be tuned in by performingTuning Up/Down or by category search.• Channels stored in preset memory can be tuned in by the presetchannel select operation, even if Parental Lock is applied.• When a channel to which Parental Lock is applied is being played,Parental Lock for that channel is cancelled by performing Step2.• See “Edit Lock Cord” (vpage 36) for the method of changingParental Lock Cord.• You can also set “Parental Lock” from the menu. (vpage 36).iPod® PlaybackThe music on an iPod can be played by using the control dock foriPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W sold separately).The operation can also be performed using the buttons on the mainunit or remote control unit while watching the menus.iPod is a trademark of Apple Inc., registered in the U.S.and other countries.b The iPod may only be used to copy or play contents that are notcopyrighted or contents for which copying or playback is legallypermitted for your private use as an individual. Be sure to complywith applicable copyright legislation.1 Make the necessary preparations.q Set the iPod in the DENON control dock for iPod.(vSee the control dock for iPod’s operating instructions.)w Assign the control dock for iPod’s input.The input for the control dock for iPod is assigned to VCR bydefault.MENU : ”Input Setup” – “Assign” – ”iPod Dock”(vpage 35)2 Either turn or press [iPod] toselect the input source assigned in step 1-w above.(iPod screen)b If the screens above are not displayed, the iPod may not beproperly connected. Try connecting again.3 Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCECONTROL 2] to “iPod/NETWORK”.(vpage 57 “Remote Control Unit Operations”)Basic OperationOK to disconnect.• With the default settings, the iPod can be used connected to theVCR (iPod) connector.• Use the RESTORER mode to expand the low and high frequencycomponents of compressed audio fi les and achieve a richer sound.The default setting is “Mode3” (vpage 44).• Press or [OFF] and set the AVR-2309CI’s power tothe standby mode before disconnecting the iPod. Also switch theinput source to one to which the menu “iPod Dock” is not assignedbefore disconnecting the iPod.• When using an ASD-3N or ASD-3W control dock for iPod, refer tothe respective manual to operate.4 Press [MODE] and hold it down for a 2 seconds ormore to select the display mode.To switch between modes, press and hold down the button.When remote mode is active, “Remote” is displayed.[Selectable mode] Browse mode Remote modeDisplay location Main unit display iPod displayPlayablefilesAudio file S SVideo file S z1 S z2ActivebuttonsRemotecontrol unit(AVR-2309CI)S SiPod A Sz1 : When using an ASD-3N or ASD-3W control dock for iPod.z2 : Video may not be output, depending on the combination ofASD-1R or ASD-11R and iPod.Playback