Denon AVR-3310CI Owner's Manual

Also see for AVR-3310CI: Specification Capabilites and Compatibilities Owner's manual Before Upgrading Guide Getting started

Contents

Denon AVR-3310CI Owner's Manual Manual pdf 35 page image

Getting Started Connections Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsMake the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)Error MessagesWhen Performing Audyssey Auto Setup OverAgainPress ui to select “Retry”, and then press ENTER.When Measuring has StoppedPress RETURN, the “Cancel auto setup?” prompt is displayed.Press o p and select “Yes”, then press ENTER.nnAn error message is displayed if it was not possible to completeAudyssey Auto Setup due to speaker placement, the measurementenvironment, etc. If this happens, check the relevant items, be sureto take the necessary measures, then perform Audyssey Auto Setupprocedure over again.NOTEBe sure to turn off the power before checking speaker connections.Error messages (examples) Error contents MeasuresIncluded setup microphone is not connected.Not all speakers could be detected.The front L speaker was not properly detected.•••Connect the included setup microphone to theSETUP MIC jack of the AVR-3310CI.Check the speaker connections.••Too much noise in the room for accuratemeasurements to be made.Speaker or subwoofer sound is too low foraccurate measurements to be made.••Either turn off any device generating noise ormove it away.Perform again when the surroundings arequieter.Check the speaker installation and the direction inwhich the speakers are facing.Adjust the subwoofer’s volume.••••Displayed speaker could not be detected.• Check the connections of the displayed speaker.•Displayed speaker connected with the polaritiesreversed.• Check the polarities of the displayed speaker.For some speakers, this error message maybe displayed even if the speaker is properlyconnected. If you are sure the connection iscorrect, press ui to select “Skip”, then pressENTER.••SettingMain remote controloperation buttons:Displaying the menuCancel the menu:Moves the cursor(Up/Down/Left/Right) :Confirm the setting :Return to previous menu