Denon AVR-488 Owner's Manual

Also see for DHT-488BA: Specifications Specifications Getting started Specification sheet Code List

Denon AVR-488 Owner's Manual Manual pdf 6 page image

30°30°Approx. 23 feet / 7 mOperating Range of the Remote ControlUnitPoint the remote control unit at the remote sensor when operating it.NOTEThe set may function improperly or the remote control unit may notoperate if the remote control sensor is exposed to direct sunlight,strong artificial light from an inverter type fluorescent lamp or infraredlight.Getting Started Connections Setup Playback Remote Control Information TroubleshootingIn addition to the AVR-488, the included remote control unit (RC-1079)can also be used to operate the equipment listed below.q DENON system componentsw Non-DENON system components• By setting the preset memory (vpage 37 ~ 39)q Lift the clasp and remove therear lid.e Put the rear cover back on.R6P/AAw Load the two batteries properlyas indicated by the marks inthe battery compartment.About the Remote Control UnitInserting the BatteriesNOTE• Replace the batteries with new ones if the set does not operate evenwhen the remote control unit is operated close to the unit.• The supplied batteries are only for verifying operation.• When inserting the batteries, be sure to do so in the proper direction,following the “q” and “w” marks in the battery compartment.• To prevent damage or leakage of battery fluid:• Do not use a new battery together with an old one.• Do not use two different types of batteries.• Do not attempt to charge dry batteries.• Do not short-circuit, disassemble, heat or dispose of batteries inflames.• If the battery fluid should leak, carefully wipe the fluid off the insideof the battery compartment and insert new batteries.• Remove the batteries from the remote control unit if it will not be inuse for long periods.• When replacing the batteries, have the new batteries ready andinsert them as quickly as possible.ENGLISH