Denon AVR-5700 Operating Instructions Manual

Also see for AVR5700 - THX Audio/Video Receiver: Service manual

Denon AVR-5700 Operating Instructions Manual Manual pdf 22 page image

227 Enter the setting.The System Setup Menu reappears.The AVR-5700 automatically sets the optimum surround delay time for the listening room.ENTERNOTE:• If the distance unit is changed after the delay time is set, the settings are reset to the factory default values (see page 16).Setting the channel level• Use this setting to adjust so that the playback level between the different channels is equal.• From the listening position, listen to the test tones produced from the speakers to adjust the level.• The level can also be adjusted directly from the remote control unit. (For details, see page 43.)• When using both surround speakers A and B, their playback levels can be adjusted separately.12345At the System Setup Menu select “Channel Level”.Switch to the Channel Level screen.Select “Test Tone Mode”.Select the mode.Select “Auto” or “Manual”.• Auto:Adjust the level while listening to the test tones producedautomatically from the different speakers.• Manual:Select the speaker from which you want to produce the test tone toadjust the level.Select “Surr. Sp.”, then select the surround speaker(s) from which you want to produce thetest tone (A, B or A+B).• Surr. Sp.: AAdjusts the balance of the playback level between the channels when using surroundspeaker A.• Surr. Sp.: BAdjusts the balance of the playback level between the channels when using surroundspeaker B.• Surr. Sp.: A+BAdjusts the balance of the playback level between the channels when using surroundspeakers A and B at the same time.2 The “Surr. Sp.” can only be selected when both surround speakers A and B have beenselected at the System Setup Menu (when both A and B have been set to “Large” orENTERExample: When the “Auto” mode is selected