Denon AVR-686S Operating Instructions Manual

Also see for AVR-686: Service manual Brochure & specs Operating instructions

43Advanced Setup Advanced SetupENGLISH• The audio delay setting does not apply when playing in the EXT.IN mode or in the analog input direct mode or stereo mode.• By default, this menu is not displayed when no digital signalsare being input.The surround mode used last for the three types of input signalsshown below is stored in the memory, and the signal isautomatically played with that surround mode the next time it isinput.Note that the surround mode setting is also stored separately forthe different input sources.q Analog and PCM 2-channel signals (STEREO)w 2-channel signals in the Dolby Digital, DTS or another multi-channel format (DOLBY PLIIx Cinema)e Multi-channel signals in the Dolby Digital, DTS or another multi-channel format (DOLBY/DTS SURROUND)Default settings are indicated in ( ).Setting the Auto Surround ModePress the CURSOR FF or GG button to select the AutoSurround mode, then press the ENTER or CURSORHH button to switch the Ext. In Subwoofer Levelsetting.* A u t o S u r r . O NON OFF• When watching a DVD or other video source, the picture on themonitor may seem delayed with respect to the sound. In thiscase, adjust the audio delay to delay the sound and synchronizeit with the picture.• The audio delay setting is stored separately for each inputsource.Setting the Audio DelayPress the CURSOR FF or GG button to set the delaytime, then press the ENTER or CURSOR HH button toswitch the Auto Surround Mode setting.With a movie source, for example, adjust so that themovement of the actors’ lips is synchronized with the sound.* A . D e l a y 0 m s0ms 100ms 200msSet the method of playback of the analog input signal connectedto the EXT. IN terminal.Setting the Ext. In Subwoofer LevelPress the CURSOR FF or GG button to select the ext. insubwoofer channel level playback, then press theENTER or CURSOR HH button to switch the PowerAmp Assignment setting.* E x t . I n S W + 1 5 d B+0dB +5dB +10dB +15dBMake this setting to switch the power amplifier for the surroundback channel to ZONE2.Setting the Power Amp AssignmentPress the CURSOR FF or GG button to select “S. Back”or “ZONE2”, then press the ENTER or CURSOR HHbutton if you want to start the settings over from thebeginning.* P . A m p S . B a c kS.Back ZONE2MAIN ZONESurround back 7.1ch systemZONE2 5.1ch systemPower AmpAssign. ZONE2–2ch systemSPEAKER OUTENGLISH