Denon AVR-789 Owner's Manual

Also see for AVR-789: Owner's manual Product Compatibility Chart Service manual Service manual Comparison chart

Denon AVR-789 Owner's Manual Manual pdf 27 page image

Getting Started Connections Playback Remote Control Multi-zone Information TroubleshootingENGLISH SpecificationsNOTEDo not turn the power off while the settings are being stored.Step 5 : StoreThe auto setup measurement results are stored in the AVR-789.q Press u to select “Store 0”, then press o.• “Storing Please wait...” is displayed on the on-screen displaywhile the results are being stored.• When storing is complete, “Storing complete. Auto Setup is nowfinished.” is displayed on the on-screen display.w Select “Exit”, then press ENTER.e Disconnect the setup microphone from the AVR-789.n To cancel storingPress ui to select “Cancel 0”, then press o.• All the measured auto setup data will be erased.F Menu screen FqwAuto SetupStep5:Store Audyssey MultEQStoreCancelPlease select “Store”to store measurementvalues.Auto SetupAudyssey MultEQStoringPlease wait...Step5:StoreNOTE Be sure to turn the power off before checking the speaker connections.Error MessagesIf the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message isdisplayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure overagain.Select “Retry” to measure again.Error messages (examples) Cause MeasuresorRetryCancelMicrophone:NoneSpeaker :NoneAuto SetupCaution!Audyssey MultEQ• Included setup microphone is not connected.• Not all speakers could be detected.• The front L speaker was not properlydetected.• Connect the included setup microphone to the SETUPMIC jack on the main unit.• Check the speaker connections.too high orRetryCancelAmbient noise isLevel is too low.Auto SetupCaution!Audyssey MultEQ• Too much noise in the room for accuratemeasurements to be made.• Speaker or subwoofer sound is too low foraccurate measurements to be made.• Either turn off any device generating noise or move itaway.• Try again when the surroundings are quieter.• Check the speaker installation and the direction inwhich the speakers are facing.• Adjust the subwoofer’s volume.RetryR :NoneCancelFrontAuto SetupCaution!Audyssey MultEQ• Displayed speaker could not be detected.· The front R speaker were not properlydetected.· Only one channel of the surround speakerswas detected.· Sound was output from the R channelwhen only one surround back speaker wasconnected.· The surround back, but the surround speakerwas not detected.• Check the connections of the displayed speaker.RetryL :PhaseCancelSkipFrontAuto SetupCaution!Audyssey MultEQ• Displayed speaker connected with thepolarities reversed.• Check the polarities of the displayed speaker.• For some speakers, this error message may bedisplayed even if the speaker is properly connected. Ifyou are sure that the wiring is correct, select “Skip”.Getting Started Connections Playback Remote Control Multi-zone Information TroubleshootingENGLISH Setup