Denon AVR-790 Owner's Manual

Also see for AVR-790: Specifications Specification Service manual Getting started Comparison chart

Denon AVR-790 Owner's Manual Manual pdf 53 page image

0ENGLISH Getting Started Connections Remote Control Information Troubleshooting SpecificationsMulti-ZoneSettings1 Press .2 Press ui to select the speaker.The speaker that can be set switches eachtime one of the buttons is pressed.3 Press o p to adjust the volume.b In the case of a subwoofer, reducing the volume when it is at“–12 dB” will change the setting to “OFF” (none).Channel VolumeFL 0.0dB SR 0.0dBC 0.0dB SBR 0.0dBFR 0.0dB SBL 0.0dBSW 0.0dB SL 0.0dBFaderFRONT : REAR[ ]:CH Sel.1 Use or i to select “Fader”, then select the itemto be adjusting using o or p.2 Press o p to adjust the volume of the speakers.• The fader function does not affect the subwoofer.• The fader can be adjusted until the volume of the speaker adjustedto the lowest value is –12 dB.1 Set the items below to the settings you want to save.q Input source (vpage 38)w Input Mode (vpage 34)e Surround Mode (vpage 42)r Audyssey Settings (MultEQ, Dynamic EQ, DynamicVolume) (vpage 46)t Volume setting (vpage 38)2 Press and hold the desired until “Memory”appears on the display.The current settings will be memorized.NOTEInput sources stored with the quick select function cannot be selectedif they have been deleted at menu “Source Delete” (vpage 30). Inthis case, store them again.Adjust the volume of thedifferent speakersYou can adjust the channel level either according to the playbacksources or to suit your taste, as described below.Saving frequently used settings(Quick Select Function)This function allows you to save all the settings shown in step1. When frequently used settings are saved, they can easily beset again the next time you want to use them. This function alsoallows you to always enjoy the same playback environment.• Three sets of settings can be saved.Saving the settingsPress the at which thesettings you want to call out are saved.Calling the settings outThis function lets you adjust (fade) the sound from all the front (Frontspeaker / center speaker / Front Height speaker) or rear (Surround speaker /Surround Back speaker) speakers at once.If headphones are plugged in, the headphones settings screenappears.The surround parameters, tone settings and the volumes of thedifferent speakers are stored for the individual surround modes.GQuick Select DefaultsHInput Source VolumeQuick Select 1 DVD –40 dBQuick Select 2 SAT/CBL –40 dBQuick Select 3 VCR/iPod –40 dBn Naming Quick Select settings“Quick Select Name” (vpage 31).Various memory functionsAdjust the volume of the different speakersAdjusting the volume of groups of speakers(Fader Function)Personal Memory Plus FunctionThis function sets the settings (input mode, surround mode, HDMIoutput mode, MultEQ, Dynamic EQ, Dynamic Volume, audio delayetc.) last selected for the individual input sources.Last Function MemoryThis stores the settings as they were directly before the standby modewas set.When the power is turned back on, the settings are restored to as theywere directly before the standby mode was set.Backup MemoryThe various settings are backed up for about 1 week, even if the poweris turned off or the power cord is disconnected.Saving the settingsIt is also possible to save three settings for ZONE2.1 Set the remote control unit’sdevice selector switches asshown on right.2 Perform steps 1 and 2 under “MAIN ZONEsettings”.MAIN ZONE settingsZONE2 settingsFrontFrontFrontPlayback