Denon AVR-982 Operating Instructions Manual

Also see for AVR-2802: Operating instructions Operating instructions Brochure & specs Operating instructions Service manual

Contents

Denon AVR-982 Operating Instructions Manual Manual pdf 42 page image

I_SURROUND• Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustmentcan be performed with the system setup (see page 22) or from the remote control unit, as described below.• Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only effective in the DOLBY/DTSSURROUND modes. The adjusted levels for the different modes are automatically stored in the memory.Press the T. TONE button.2{Remote contlo[ unJtlTest tones are output from the different speakers. Use thechannel volume adjust buttons to adjust so that the volume ofthe test tones is the same for all the speakers.{Remote control unitlAfter completing the adjustment, press the T. TONE buttonagain.{Remote control unit}• After adjusting using the test tones, adjust the channel levels either according to the playback sources or to suit your tastes, as described below.Select the speaker whose level you want to adjust.CH VOL{Main unit) (Remote control unit)The channel switches as shown below each time the buttonis pressed.OL::: )D_2 12 Adjust the level of the selected speaker.SELECT(Main unit)Only adjustable when thechannel is selected with theCH VOL buttons on the mainunit.S(Remote control unit)NOTES:• The adjustment range for the different channels is +12 dB to-12 dB.• When using the DIRECT mode, the sound from the subwoofercan be cut by lowering the SW (subwoofer) setting one stepfrom -12 dB (setting it to "OFF").When the surround back speaker setting is set to "2spkrs" for"Speaker Configuration", this is set to "SBR", "SBL".142