Denon AVR-E300 Service Manual

Also see for AVR-E300: Owner's manual Getting started Getting started

Contents

17SPECIAL MODESpecial mode setting button ( for E300 model)b No.1 - 9 : Press the X button to turn on the power while pressing both the button A,B and the button C at the same time.b No.10 : Turn on the power, then press and hold down A and B buttons for over 3 second.No. Mode Button A Button B Button C Contents1 Version display(μcom/DSP Error Display) DIMMER STATUS -Firmware versions such as Main or DSP are displayed in theFL manager. Errors are displayed when they occur.(Refer to 20 page)2Errors checking(Displaying the protection historymode)TUNERPRESET CH + DIMMER STATUS The protection history is displayed.(Refer to 23 page)3User Initialization(Installer Setup settings are notinitialized.)SOURCESELECT 0SOURCESELECT 1 - Backup data initialization is carried out.(Installer Setup settings are not initialized.)4Factory initialization(Installer Setup settings arealso initialized)TUNERPRESET CH + DIMMER - Backup data initialization is carried out.(Installer Setup settings are also initialized)5 Mode for preventing remotecontrol acceptanceSOURCESELECT 1TUNERPRESET CH + -Operations using the remote control are rejected.Press the SOURCE SELECT 0/1 to select "RC LOCK On",then press the "STATUS" button to set.(Mode cancellation: Execute the same button operations aswhen performing setup and select "RC LOCK Off".)6 Panel lock ↑ ↑ -Operations using the main unit panel buttons or the mastervolume knob are rejected.Press the SOURCE SELECT 0/1 to select "FP/VOL LOCKOn", then press the "STATUS" button to set.7 Panel lock(Master volume is not locked.) ↑ ↑ -Operations using the main unit panel buttons are rejected.Press the SOURCE SELECT 0/1 to select "FP LOCK On",then press the "STATUS" button to set.8 Cancellation of panel lock ↑ ↑ -Panel lock mode is cancelled.(Mode cancellation: Execute the same button operations aswhen performing setup and select "FP LOCK Off", then pressthe "STATUS" button to set.)9 Diagnostic TUNERPRESET CH + DIMMER STATUSThis mode is used for confirming the Video and Audio signalpaths. (Troubleshooting)The signal paths of the set can be easily confirmed afterrepair.(Refer to 29 page)10 Remote ID Setup DIMMER STATUS -When using multiple DENON AV receivers in the sameroom, make this setting so that only the desired AV receiveroperates.(Refer to 25 page)XSOURCE SELECT 1 TUNER PRESET CH +SOURCE SELECT 0 DIMMER STATUS