o Cannot connect to a wireless LAN networkSymptom Cause / Solution PageCannot connect to thenetwork.0 The network name (SSID), password and encryption setting have not been set up correctly. Configure thenetwork settings according to the setting details of this unit.2000 Shorten the distance from the wireless LAN access point and remove any obstructions to improve accessfirst before re-connecting again. Place the unit away from microwave ovens and other network accesspoints.－0 Configure the access point channel settings away from channels that are being used by other networks. －0 This unit is not compatible with WEP (TSN). －Cannot connect to WPS. 0 Check that the WPS mode of the router is operating. －0 Press the WPS button on the router and then press the “Connect” button displayed on the TV within 2minutes.－0 A router/settings that are compatible with WPS 2.0 standards are required. Set the encryption time to“None”, “WPA-PSK (AES)” or WPA2-PSK (AES).2000 If the router encryption method is WEP/WPA-TKIP/WPA2-TKIP, you cannot connect by using the WPSbutton. In this case, use the “Scan Networks” or “Manual” method to connect.－Cannot connect to thenetwork using iPhone/iPodtouch/iPad.0 Update the iPhone/iPod touch/iPad firmware to the latest version. －0 When using a USB cable to configure the settings, the iOS device firmware version needs to support iOS5 or later. When configuring the settings via a wireless connection, iOS 7 or later needs to be supported.－Contents Connections Playback Settings Tips Appendix234Front panel Display Rear panel Remote Index
