Denon D-M51DVS Operating Instructions Manual

Also see for ADV-M51: Operating instructions Specification sheet Service manual Operating instructions Operating instructions

Denon D-M51DVS Operating Instructions Manual Manual pdf 84 page image

84ENGLISH(1) Setting the clock (24-hour display)18 USING THE TIMER1 Turn on the power.2 Press the MENU/SET button to display “Time”.MENU/SETMain unit• If the time has not yet been set or if there has been apower shortage, the time display flashes.• If the time has been set, the current time is displayed.3 Press the MENU/SET button and hold it in for over 2 seconds.• The hours position flashes.T i m e 0 : 0 0A d j 0 : 0 0 MENU/SETMain unitExample: Setting the current time to “19:30”6 Turn the SURROUND/SELECT knob to move to the minutesposition.A d j 19 : 3 0 SURROUND / SELECTPUSH - PARAM.Main unit7 Press the MENU/SET button at the sound of a time signal,etc.• The “30” in the minutes place stops flashing and thecurrent time is displayed.T i m e 19 : 3 0 MENU/SETMain unitTo check the current time when the regular display is displayed,press the MENU/SET button once. The current time remainsdisplayed until some other operation is performed.The time can be displayed by pressing the MENU/SET buttonwhen the power is in the standby mode. (When this is done, theset is no longer in the low power consumption standby mode.)When pressed twice while the time is displayed, the display turnsoff and the set is put back in the low power consumption standbymode.The current time can also be set when the power is in the standbymode by pressing the MENU/SET button to display the time thenperforming steps 3 to 7.The clock runs by synchronizing with the power supply frequency.The time may be off by 2 to 3 minutes per month. If so, reset thetime.DVD SURROUND RECEIVER ADV-M51 SURROUND SELECTPUSH-PARAMFUNCTIONMENU SETTONE SDBBANDVOLUMEPHONESON STANDBYV I D E ORadioCONPACTDIGITAL VIDEOPRO LOGICVIRTUAL SPEAKER US U R R OD I G I TN DA LWMAMP14,6 2,3,5,72 Timer and system operations are possible once the setup procedure has been completed.4 Turn the SURROUND/SELECT knob to set the hours.A d j 1 9 : 0 0SURROUND / SELECTPUSH - PARAM.Main unit5 Press the MENU/SET button.MENU/SETMain unitA d j 19 : 0 02 Be sure to set the current time. If the current time is not set, the timer standby indicator does not light and the timer will not function.2 Be sure to preset the broadcast station before setting the timer. (See page 61.)2 Everyday timer: The power is switched on and off (standby) once at the same time each day.Once timer: The power is switched on and off (standby) at the specified time once only.Sleep timer: The power can be set to turn off in 120 minutes, 90 minutes, or between 60 and 10 minutes in 10 minute steps.2 If the times set for the everyday timer, once timer and sleep timer overlap, the sleep timer has priority. The once time has priority if the everydaytimer and once timer times overlap.2 It is not possible to set the timer start and stop times to the same time.ON / STANDBYMain unitBefore setting the timer