Denon D-T1 Owner's Manual
Also see for D-T1: Quick start guideService manualQuick start guide
                                                                        | |
Contents
| 
Connecting speakersHere we connect the speakers in the room to this unit.This section explains how to connect them using typical examples.NOTE0 Disconnect this unit’s power plug from the power outlet before connecting thespeakers.0 Connect so that the speaker cable core wires do not protrude from the speakerterminal. The protection circuit may be activated if the core wires touch the rearpanel or if the + and - sides touch each other. “Protection circuit” (v p. 66)0 Never touch the speaker terminals while the power cord is connected. Doing socould result in electric shock.0 Use speakers with an impedance of 6 – 16 Ω/ohms.Connecting the speaker cablesCarefully check the left (L) and right (R) channels and + and – polarities onthe speakers being connected to this unit, and be sure to connect thechannels and polarities correctly.1 Peel off about 10 mm of sheathing from the tip of thespeaker cable, then twist the core wire tightly. .2 Push the lever of the speaker terminal and insert thespeaker cable into the cable insertion slot. .3 Release your finger from the speaker terminal lever tofix the speaker cable. .Contents Connections Playback Settings Tips Appendix17Front panel Rear panel Remote controlunit Index |
Related manuals for Denon D-T1
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine