Troubleshooting11ENGLISHPageMeasuresCauseSymptomTroubleshootingIf a problem should arise, first check the following.1. Are the connections correct?2. Have you operated the player according to the Operating Instructions?If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.Disconnect the power immediately and contact your store of purchase.Disc tray does not open. • The power is not on. • Turn on the power. 7“0 000 00:00” is displayed eventhough a disc is loaded.• The disc is not properly loaded.• The loaded disc is not a CD.• Reload the disc.• Load a CD.2, 32Disc is not played when 1 button ispressed.• The disc is dirty or scratched. • Wipe the dirt off the disc or replace the disc. 3No sound is produced or sound isdistorted.• The output cables are not properly connected to theamplifier.• The amplifier’s function setting or adjustments arenot right.• Check the connections.• Check the amplifier’s function and controls andadjust as necessary.6–No digital signals are output. • The connection cables are not properly connected. • Check the connections. 6Specific section of the disc cannot beplayed properly.• The disc is dirty or scratched. • Wipe the dirt off the disc or replace the disc. 3Programmed playback is not possible. • The tracks have not been programmed properly. • Program properly. 9A CD-R or CD-RW disc cannot beplayed.• The disc has not been finalized.• The recording conditions are bad or the quality of thedisc itself it poor.• Finalize the disc then play it.• Use a properly recorded disc.22Set does not operate properly whenremote control unit is operated.• The batteries are spent.• The remote control unit is too far from the set.• Replace the batteries with new ones.• Move the remote control unit closer to the set.33“– – : – –” is displayed when playingfiles recorded in MP3 or WMA format.• You have selected a copyright-protected WMA fileor a file that cannot be played normally.• Use the 8/6 or 7/9 button on the mainunit (the 8 or 9 button on the remote controlunit) to select a different file.2ENGLISH