Denon DN-S3000 Operating Instructions Manual

Also see for DN-S3000: Service manual Operating instructions Manual

Contents

Denon DN-S3000 Operating Instructions Manual Manual pdf 20 page image

ABB∗20ENGLISHGENERALType: Compact disc playerDisc type: Standard compact discs (12 cm discs), CD-TEXTCD-R, CD-RW discsNOTE: Finalized CD-R or CD-RW discs can be played back in this unit.However, according to recording quality, some CD-R/RW discscannot be played.Dimensions: Player unit: 285 (W) x 111.5 (H) x 327 (D) mm (without feet)11-7/32” (W) x 4-25/64” (H) x 12-7/8” (D)Installation: Table top typeMass: Player unit: 6.0 kg (12 lbs 9 oz)Power supply: U.S.A., Canada and Taiwan R.O.C. models: 120 V AC ±10%, 60 HzEuropean models: 230 V AC ±10%, 50 HzPower consumption: 16 WEnvironmental conditions: Operational temperature: 5 to 35°C (41 to 95°F)Operational humidity: 25 to 85% (no condensation)Storage temperature: –20 to 60°C (4 to 140°F)AUDIO SECTIONMain out, Monitor outQuantization: 24-bit linear per channelSampling frequency: 44.1 kHz at normal pitchOversampling rate: 8 timesTotal harmonic distortion: 0.01% or lessSignal to noise ratio: 90 dB or moreChannel separation: 85 dB or moreFrequency response: 20 to 20,000 HzAnalog outputOutput level: 2.0 V r.m.s.Load impedance: 10 kΩ/kohms or moreDigital outputSignal format: IEC958-Type IIOutput level: 0.5 Vp-p 75 Ω/ohmsFUNCTIONSInstant start: Within 20 msec.Variable pitch: ±4% (0.02% pitch), ±10% (0.1% pitch), ±16% (0.1% pitch)±24% (0.1% pitch), ±50% (0.5% pitch) ±100% (1.0% pitch)Pitch bend: Pitch range ±32%Pitch range ±100%: ±99%SamplerSampling: 44.1 kHzLength: 15 sec.Output level: 2.0 V r.m.s. (Variable / -14 ~ +6 dB)Variable pitch: ±24% (0.1% pitch)Search precision: 1/75 sec. (1 subcode frame)Max. scan speed: Over 20 times normal speedMax. MEMO memory steps: 5000 steps✽ Specifications and design are subject to change without notice for purpose of improvement.15 SPECIFICATIONS1. Remove a screw (Hexagon socket head) andpull out Scratch Disc and Slip Mat.2. Remove Belt from Motor Pully.3. Remove 3 screws (< head) and pull outPlatter.4. Remove Belt from Platter.5. Mount in the order 4 → 1.BAPlatterStabilizer(Hexagon socket head) Scratch DiscSlip MatBeltMotor Pully(< head)CAUTIONS:• Unplug the power cord before replacing thebelt.• Do not touch the sensor or scale(∗) whenremoving the Platter.• Do not apply oil or grease to the belt whenreplacing it.BeltPlatter(< head)16 REPLACING THE BELT• On the DN-S3000, the platter is driven by a belt. In the unlikely case of trouble, use the procedure describedbelow to replace the belt.Slip Sheet